CALIBRATION

 calibration set up for pressure transmitter rosemount
in processing set up or calibration
1. check first the pressure controls of waht is his set-up to the power.
either normally open/normally close base on the setting/cut in and the reset/cut out and then convect to the input to NO.NCCompose
2. open/switch on the power for starting the calibration of instrument
3. release the hydraulic pressure and start to hand pump the hydraulic
4. in calibrating the instrument to get the setting/ cut in and the reset cut out adjust the setting adjuster and or differntial adjuster to get the exact setting fo the instruemtn using the hyraulic pressure simulation